201285 201285 201427 201439 201285018 201285019 201285020 201285021 201285022 201285023 201285024 201285025 201285026 201285027 201285028 201285029 201285030 201285032 201285033 201285035 201285036 201285038 201285040 201285045 201285050 340 1 2 I 7.98 × 130 mm 1 2 Weldon Weldon 19 mm 80 mm I 7.98 × 130 mm Art. mm I 18 I 19 I 20 I 21 I 22 I 23 Art. mm I 24 I 25 I 26 I 27 I 28 I 29 Art. mm 1 0 I 30 1 0 I 32 1 0 I 33 1 0 I 35 1 0 I 36 1 0 I 38 Art. mm 2 128 040 I 40 2 128 045 I 45 2 128 050 I 50 1428 ANNULAR CUTTERS CONTACT INFORMATION For more information please call +1 330 928 7744 or send an email to ataorders@atatools.com It is possible to use this one-piece ejector pin in combination with tool holder article 20 1842, 20 1291, 20 1843, 20 1845, 20 1846 (see pages 464– 465). You can drill as deep as 4-21/64" (110 mm) in one working process without changing. Robust and easy. EJECTOR PINS 2-PIECE APPLICATION EJECTOR PINS 2-PIECE Application: Insert piece 1 into the annular cutter shank. Push piece 2 onto part 1. Drill as deep as 1-31/32" (50 mm) cutting depth. Then remove piece 2 and continue drilling. 2 piece HSS-XE + DURABLUE-coated annular cutter, Weldon shank, drill depth 80 mm Further see Art. 20 1650 page 310. Why use 2-part ejector pins? Usually, standard morse taper holders have a cutting depth capacity of 1-31/32" (50 mm). If no extra-long holders are used (e.g. as on pages 464–465 Art. 20 1842, 20 1291, 20 1843, 20 1845, 20 1846), then you need to use 2-part ejector pins for drill depths above 1-31/32" (50 mm). Alu Steel Stainless Copper, brass, tin Plastics GRP/CRP Gray cast iron APPLICATION EJECTOR PINS 1-PIECE 1 piece Packaging unit 2 pcs. Packaging unit 2 pcs. ACCESSORIES Hardox 400, 450 Cutting data Movie < 1100 N < 900 N > 10% Si BLUE-DRILL LINE 80 BLUE-DRILL LINE 80 11 Index 10 9 OIL 8 7 6 5 4 3 2 1
RkJQdWJsaXNoZXIy MTgxNTQ=