376 < 1400 N E H I N H > 900 N > 10% Si CONTACT INFORMATION For more information please call +1 330 928 7744 or send an email to ataorders@atatools.com CARBIDE-TIPPED ANNULAR CUTTERS PROPERTIES Karnasch carbide tipped annular cutters (HARD-LINE) are made with a conical helix for: clean chip flow and highest cutting ability even with difficult materials. Karnasch carbide tipped annular cutters (HARD-LINE) are made in an elaborate pre-/ intermediate-/after-cutting geometry This results in: clatter-free, silent and easy cutting with highest lifetimes. Karnasch carbide tipped annular cutters (HARD-LINE) are exclusively equipped with Sandvik carbide teeth. Our opinion is: Only the best carbide is good enough for Karnasch annular cutters. Steel Stainless Alu Copper, brass, tin Plastics GRP/CRP Gray cast iron Graphite Rails Hastelloy, Inconel, Nimonic, exotic materials APPLICATION OPTIMAL GOOD POSSIBLE The best annular cutters are carbide tipped. These cutters offer the best cost benefit across a variety of materials. Carbide tipped annular cutters provide maximum cutting capacity in materials such as: • Hardened steel up to 40 Rockwell (HRC) • A variety of stainless steels • Challenging alloys (Hardox, Inconel, and Titan) • All non-ferrous metals such as aluminum, copper, and brass Available in 12-65 mm (1/2" to 2-29/16") diameters and drill depths of 40 mm (1-1/2"), 55 mm (2"), 80 mm (3"), and 110 mm (4"). Karnasch has the world's largest stock range of carbide tipped annular cutters. HARD-LINE 11 Index 10 9 OIL 8 7 6 5 4 3 2 1
RkJQdWJsaXNoZXIy MTgxNTQ=