1359 The drip rates shown are approximate settings. If there is too much oil from the exhaust of the machine, the drip rate should be reduced slightly. These drip rates may not apply to lubrication units from other manufacturers. It is easiest to begin with a high drip rate, and reduce to the correct setting. Motor Power Micro fog Unit Size Drips per Minute kw hp 0.1 0.2 1/4" 10 0.2 0.2 1/4" 10 0.2 0.3 1/4" 12 0.2 0.3 1/4" 15 0.3 0.4 1/4" 15 0.4 0.5 1/4" 15 0.6 0.9 1/4" 20 0.7 0.9 1/4" 20 0.8 1.1 1/4" 20 1.1 1.5 1/2" 20 1.5 2.0 1/2" 30 2.2 3.0 1/2" 30 ACCESSORIES Part Number Type Connection Theard SCFM CU.M/min AFLRG-1/4 Automatic drain filter with micro fog lubricator and mounting bracket 1/4" 40 1.2 AFLRG-1/2 Automatic drain filter with regulator, gauge, micro fog lubricator and mounting bracket 1/2" 120 3.4 LUBRICATION LUBRICATION OIL ATA Vitalizer The ATA vitalizer units remove moisture and harmful solids from the air stream and creates an airborne ‘micro fog’ of oil which lubricates your ATA air motor, maintaining performance and ensuring long service life. Gear lubrication: Part number: 008/GEARLUBE-1L All ATA right angle grinders and sanders are fitted with high quality gears. In order to maximise the service life of the gears it is necessary to ensure that they are properly lubricated. ATA tools utilize a slow release oiling system which releases the oil onto the gears when the tool is running and re-absorbs the oil when the tool is stopped. Where tools are in constant use the oil should be replenished daily through the oil screw fitted in the angle head of the tool. ATA recommends the use of ATA Gear lube or any high quality 68cSt gear oil. Failure to lubricate gears will void all warranties. Motor lubrication: Part number: 008/ATALUBE-1L ATA recommends the use of ATALUBE air motor oil (or other high quality 10cSt oil) in all vane type motors when using ATA Micro Fog Lubricators. The oil drip rate can be set as shown in the table, remember that only 10% of the drip is actually delivered to the air supply, the remainder is returned to the main oil reservoir. Failure to properly lubricate a vane motor will void all warranties. Note: With turbine models such as the ST100 and SPT Line, lubrication oil should NOT be used. 11 Index 10 9 OIL 8 7 6 5 4 3 2 1
RkJQdWJsaXNoZXIy MTgxNTQ=