201280 201280 201428 201399 201280018 201280019 201280020 201280021 201280022 201280023 201280024 201280025 201280026 201280027 201280028 201280029 201280030 201280032 201280033 201280035 201280036 201280038 201280040 201280045 201280050 416 1 2 I 7.98 × 157 mm Weldon Weldon 19 mm 3/4" 110 mm | 4" I 7.98 × 160 mm 2 1 Art. mm I 18 45/64" I 19 3/4" I 20 25/32" I 21 53/64" I 22 55/64" I 23 29/32" Art. mm I 24 15/16" I 25 63/64" I 26 1.1/32" I 27 1.1/16" I 28 1.7/64" I 29 1.9/64" Art. mm I 30 1.3/16" I 32 1.17/64" I 33 1.19/64" I 35 1.3/8" I 36 1.27/64" I 38 1.1/2" Art. mm I 40 1.37/64" I 45 1.49/64" I 50 1.31/32" 1564 ANNULAR CUTTERS CONTACT INFORMATION For more information please call +44 1530 261 145 or send an email to sales@atagarryson.com EJECTOR PINS 2-PIECE APPLICATION EJECTOR PINS 2-PIECE Application: Insert piece 1 into the annular cutter shank. Push piece 2 onto part 1. Drill as deep as 50 mm cutting depth. Then remove piece 2 and continue drilling. HSS-XE + DURABLUE-coated annular cutter, Weldon shank, drill depth 110 mm | 4" Further see Art. 20 1660 page 386 ∙ Attention: The inch sizes do not correspond exactly to the mm diameters. Why use 2-part ejector pins? Usually, standard morse taper holders have a cutting depth capacity of 50 mm. If no extra-long holders are used (e.g. as on pages 536–537 Art. 20 1842, 20 1291, 20 1843, 20 1845, 20 1846), you need for drill depths above 50 mm 2-part ejector pins. Alu Steel Stainless Copper, brass, tin Plastics GRP/CRP Grey cast iron APPLICATION It is possible to use this one-piece ejector pin in combination with tool holder article 20 1842, 20 1291, 20 1843, 20 1845, 20 1846 (see pages 536–537). You can drill as deep as 110 mm in one working process without changing. Robust and easy. EJECTOR PINS 1-PIECE 2 piece 1 piece Packaging unit 2 pcs. Packaging unit 2 pcs. ACCESSORIES Hardox 400, 450 Inch Inch Inch Inch Cutting data Movie < 1100 N < 900 N > 10% Si BLUE-DRILL LINE 110 BLUE-DRILL LINE 110 11 Index 10 9 OIL 8 7 6 5 4 3 2 1
RkJQdWJsaXNoZXIy MTgxNTQ=