201280U 201280U 201428 201399 201280u018 201280u019 201280u020 201280u021 201280u022 201280u023 201280u024 201280u025 201280u026 201280u027 201280u028 201280u029 201280u030 201280u032 201280u033 201280u035 201280u036 201280u038 201280u040 201280u045 201280u050 426 I 7.98 × 157 mm 1 2 I 7.98 × 160 mm 1 2 Weldon Weldon 19 mm 3/4" 110 mm | 4" Art. mm I 18 45/64" I 19 3/4" I 20 25/32" I 21 53/64" I 22 55/64" I 23 29/32" Art. mm I 24 15/16" I 25 63/64" I 26 1.1/32" I 27 1.1/16" I 28 1.7/64" I 29 1.9/64" Art. mm I 30 1.3/16" I 32 1.17/64" I 33 1.19/64" I 35 1.3/8" I 36 1.27/64" I 38 1.1/2" Art. mm I 40 1.37/64" I 45 1.49/64" I 50 1.31/32" 1564 ANNULAR CUTTERS CONTACT INFORMATION For more information please call +44 1530 261 145 or send an email to sales@atagarryson.com EJECTOR PINS 2-PIECE APPLICATION EJECTOR PINS 2-PIECE Application: Insert piece 1 into the annular cutter shank. Push piece 2 onto part 1. Drill as deep as 50 mm cutting depth. Then remove piece 2 and continue drilling. 2 piece HSS-XE annular cutter, Weldon shank, drill depth 110 mm | 4" Further see Art. 20 1660 page 386 ∙ Attention: The inch sizes do not correspond exactly to the mm diameters. Why use 2-part ejector pins? Usually, standard morse taper holders have a cutting depth capacity of 50 mm. If no extra-long holders are used (e.g. as on pages 536–537 Art. 20 1842, 20 1291, 20 1843, 20 1845, 20 1846), you need for drill depths above 50 mm 2-part ejector pins. Alu Steel Stainless Copper, brass, tin Plastics GRP/CRP Grey cast iron APPLICATION It is possible to use this one-piece ejector pin in combination with tool holder article 20 1842, 20 1291, 20 1843, 20 1845, 20 1846 (see pages 536–537). You can drill as deep as 110 mm in one working process without changing. Robust and easy. EJECTOR PINS 1-PIECE 1 piece Packaging unit 2 pcs. Packaging unit 2 pcs. ACCESSORIES Hardox 400, 450 Cutting data Movie Inch Inch Inch Inch < 900 N < 900 N < 10% Si GOLD-DRILL LINE 110 GOLD-DRILL LINE 110 11 Index 10 9 OIL 8 7 6 5 4 3 2 1
RkJQdWJsaXNoZXIy MTgxNTQ=